Saving the Configuration 287
Verifying the Interface Configuration 287
Verifying the Per-Port Interface Status 287
Configuration Examples 288
Inverting the Clock Signal Configuration Example 288
NRZI Format Configuration Example 288
Cyclic Redundancy Checks Configuration Example 288
Encapsulation Configuration Example 288
Distributed Multilink PPP Configuration Example 289
CHAPTER 19
Configuring the 1-Port Channelized OC-3/STM-1 SPA and 1-Port Channelized OC-12/STM-4
SPA 291
Restrictions for Configuring the 1-Port Channelized OC-12/STM-4 SPA 291
Configuration Tasks 291
Specifying the Physical Address for Controller and Interface Configuration 292
Naming the Interface 292
Required Configuration Tasks 293
Configuring the Controller for the SONET Mode and the SDH Mode 293
Configuring the SONET Mode 294
Configuring the SDH Mode 295
Configuring the Channelized DS3 Mode 297
Configuring DS1 (Channelized T3 mode) 299
Configuring E1 (Channelized T3/E3 mode) 301
Configuring the Unchannelized E3 Serial Interface 303
Verifying the Interface Configuration 304
Optional Configurations 305
Configuring the Encapsulation Method 305
Configuring the CRC Size for T1 306
Configuring FDL 307
Verifying FDL 308
Configuring FRF.12 309
Configuring Multilink Point-to-Point Protocol (Hardware-Based on the QFP) 309
MLPPP Configuration Guidelines 309
Creating a Multilink Bundle 309
Assigning an Interface to a Multilink Bundle 310
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
xvi OL-14127-17
Contents
To Next Page
Loading...
Need help?
General
