Cisco ASR 1000 Series

Table 45: Hardware and Software Compatibility for Ingress Classification Scheduling
New and Modified CommandsForwarding Processors, Carrier
Cards, and SPA Types
Supported
Processor EnginePlatform
Following is the list of new and
modified commands:
•
ingress-class-map
•
map ip all queue
•
map ip dscp-based
•
map ip dscp
•
map ip
precedence-based
•
map ip precedence
•
map ipv6 all queue
•
map ipv6 tc
•
map mpls all queue
•
map mpls exp
•
plim qos input class-map
•
show ingress-class-map
•
plim qos input map cos
{enable | inner-based |
outer-based | {inner |
outer} {cos-value |
cos-range} queue
{strict-priority | 0}}
•
hw-module subslot
{slot/subslot} qos input
{weight weight}
Forwarding Processors
supported
•
ESP 5, ESP 10, ESP 20,
ESP 40
SIPs supported
•
CC 10
•
CC 40
SPAs supported
•
POS SPA: OC3, OC12,
OC48, and OC192 flavors
•
Channelized SPA: ChT1/
E1, ChT3/ DS0, ChSTM1/
OC3, and ChOC12/ DS0
SPAs
•
Clear Channel SPA: T3/
E3 and 12-in-1 SPAs
•
Ethernet SPAs: FE, 1 GE,
10 GE SPAs.
•
ATM SPAs: OC-3 and
OC-12 flavour SPAs.
Cisco IOS XE Release 3.1S
•
Route Processor 1 (RP1)
•
Route Processor 2 (RP2)
Cisco ASR 1000 Series Router
The above listed new commands for ingress classification and scheduling are documented in the Cisco
IOS Quality of Service Solutions Command Reference guide at the URL http://www.cisco.com/en/US/
docs/ios/qos/command/reference/qos_book.html.
Note
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 433
Classifying and Scheduling Packets for the ASR 1000 Series Aggregation Services Routers
Prerequisites for Ingress Classification and Scheduling