Cisco ASR 1000 Series Software Configuration Guide

no ip address
negotiation auto
!
interface GigabitEthernet0/0/3
no ip address
negotiation auto
!
interface GigabitEthernet0
vrf forwarding Mgmt-intf
no ip address
negotiation auto
!
interface CEM0/1/0
no ip address
cem 1
cem class cemqos
!
cem 6
xconnect 10.10.10.10 3 encapsulation mpls
!
cem 7
xconnect 10.10.10.11 2 encapsulation mpls
!
!
interface Virtual-cem0/1/24
no ip address
!
ip forward-protocol nd
!
no ip http server
no ip http secure-server
!
logging esm config
!
!
!
control-plane
!
!
!
!
!
line con 0
stopbits 1
line vty 0 4
login
!
exception data-corruption buffer truncate
end
Router# show int cem 0/1/0
CEM0/1/0 is up, line protocol is up
Hardware is Circuit Emulation Interface
MTU 1500 bytes, BW 155520 Kbit/sec, DLY 0 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation CEM, loopback not set
Keepalive not supported
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 64000 bits/sec, 250 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
1779066 packets input, 56930112 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
Router# show class cem cemqos
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 545
Configuring the Circuit Emulation over Packet Shared Port Adapter
Verifying the Interface Configuration

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English