D-Link DGS-1100-06/ME - Show Bandwidth_Control; Config Qos Mode

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
108
 no_limit – Indicates no limit is defined.
 <value 64–1000000>] – Indicates a range between 64-
1000000 kbps.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure bandwidth control configuration:
DGS-1100-06/ME:5#config bandwidth_control all rx_rate no_limit tx_rate
no_limit
Command: config bandwidth_control all rx_rate no_limit tx_rate no_limit
Success
DGS-1100-06/ME:5#
show bandwidth_control
Purpose
To display bandwidth control settings on the Switch.
Syntax
show bandwidth control {[<portlist> | all]}
Description
The show bandwidth_control command displays bandwidth
control.
Parameters
<portlist> – A port or range of ports to be configured.
all – Specifies that the show bandwidth_control command applies
to all ports on the Switch.
Restrictions
None.
Example usage:
T o display the bandwidth control configuration:
DGS-1100-06/ME:5#show bandwidth_control
Command: show bandwidth_control
Port RX Rate Tx Rate
---- ------- -------
1 no_limit no_limit
2 no_limit no_limit
3 no_limit no_limit
4 no_limit no_limit
5 no_limit no_limit
6 no_limit no_limit
Total entries : 10
DGS-1100-06/ME:5#
config qos mode
Purpose
To configure the QoS mode.