D-Link DGS-1100-06/ME - Port Mirroring Commands; Enable Mirror; Disable Mirror

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
121
18
PORT MIRRORING COMMANDS
The Port Mirroring commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable mirror
disable mirror
config mirror target
<short 1-28> [add | delete] source ports <portlist> [both | rx | tx]
show mirror
Each command is listed in detail, as follows:
enable mirror
Purpose
Used to enable a previously entered port mirroring configuration.
Syntax
enable mirror
Description
The enable mirror command, combined with the disable mirror
command below, allows the user to enter a port mirroring
configuration into the Switch, and then turn the port mirroring on and
off without having to modify the port mirroring configuration.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable the mirroring feature:
DGS-1100-06/ME:5#enable mirror
Command: enable mirror
Success
DGS-1100-06/ME:5#
disable mirror
Purpose
Used to disable a previously entered port mirroring configuration.
Syntax
disable mirror
Description
The disable mirror command, combined with the enable mirror
command above, allows the user to enter a port mirroring
configuration into the Switch, and then turn the port mirroring on and
off without having to modify the port mirroring configuration.
Parameters
None.