D-Link DGS-1100-06/ME - Show Limited_Multicast_Addr Ports; Config Max_Mcast_Group Ports

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
171
To configure ports 1 and 3 to set the IPv6 multicast address profile id 1:
DGS-1100-06/ME:5#config limited_multicast_addr ports 1,3 ipv6 add profile_id 1
Command: config limited_multicast_addr ports 1,3 ipv6 add profile_id 1
Success.
DGS-1100-06/ME:5#
show limited_multicast_addr ports
Purpose
Used to show the per-port Limited IP multicast address range.
Syntax
show limited_multicast_addr ports <portlist> {[ipv4 | ipv6]}
Description
The show limited_multicast_addr ports command is to display the
multicast address range by port or by VLAN.
Parameters
<portlist> – Used to show the per-port Limited IP multicast address
range.
[ipv4 | ipv6] – Specify the IPv4 or IPv6 of limited multicast address to
be displayed.
Restrictions
None.
Example usage:
To show the IPv4 limited multicast address on ports 1 and 3:
DGS-1100-06/ME:5#show limited_multicast_addr ports 1,3 ipv4
Command: show limited_multicast_addr ports 1,3 ipv4
Port Access Profile ID List
---- ----------- --------------------------------------------------------------
1 (v4) Permit
3 (v4) Permit
DGS-1100-06/ME:5#
config max_mcast_group ports
Purpose
Used to configure the maximum number of multicast groups that a
port can join.
Syntax
config max_mcast_group ports <portlist> [ipv4 | ipv6]
max_group <integer 1-32>
Description
The config max_mcast_group ports command is used to
configure the maximum number of multicast groups that a port can
join.
Parameters
<portlist> – A range of ports to configure the maximum multicast
group.
[ipv4 | ipv6] – Specify the IPv4 or IPv6 to be configured.
max_group <integer 1-32> – Specifies the maximum number of
multicast groups. The range is from 1 to 32.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage: