D-Link DGS-1100-06/ME - Access Authentication Control Commands

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
213
34
ACCESS AUTHENTICATION CONTROL COMMANDS
The Access Authentication Control commands in the Command Line Interface (CLI) are listed (along
with the appropriate parameters) in the following table.
Command
Parameter
create authen_login
method_list_name
<string 15>
config authen_login
[default | method_list_name <string 15>] method [ radius | local | server_group
<string 15> | none]
delete authen_login
method_list_name
<string 15>
show authen_login
[all | default | method_list_name <string 15>]
create authen_enable
method_list_name
<string 15>
config authen_enable
[default | method_list_name <string 15>] method {radius | local | server_group
<string 15> | none}
delete authen_enable
method_list_name
<string 15>
show authen_enable
[all | default | method_list_name <string 15>]
enable authen_policy
disable authen_policy
show authen_policy
config authen
application
[console | http | all] [login | enable] [default | method_list_name <string 15>]
show authen
application
config authen
parameter
[attempt <int 1-255> | response_timeout <int 0-255>]
show authen
parameter
create authen
server_host
[<ipaddr>| ipv6address <ipv6addr>] protocol radius {port <int 1-65535> | key
[<string 254> | none] | timeout <int 1-255> | retransmit <int 1-255>}
config authen
server_host
[<ipaddr> | ipv6address <ipv6addr>] protocol radius {port <int 1-65535> | key
[<string 254> | none] | timeout <int 1-255> | retransmit <int 1-255>}
delete authen
server_host
[<ipaddr> | ipv6address <ipv6addr>] protocol radius
show authen
server_host
create authen
<string 15>