D-Link DGS-1100-06/ME - Enable Snmp Authenticate Trap; Disable Snmp Authenticate Trap; Config Syslocation

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
56
enable snmp authenticate trap
Purpose
To enable SNMP authentication trap support.
Syntax
enable snmp authenticate trap
Description
The enable snmp authenticate trap command enables SNMP
authentication trap support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command
Example usage:
To turn on SNMP authentication trap support:
DGS-1100-06/ME:5#enable snmp authenticate traps
Command: enable snmp authenticate traps
Success!
DGS-1100-06/ME:5#
disable snmp authenticate trap
Purpose
To disable SNMP authentication trap support.
Syntax
disable snmp authenticate trap
Description
The disable snmp authenticate trap command disables SNMP
authentication trap support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command
Example usage:
To disable the SNMP authentication trap support:
DGS-1100-06/ME:5#disable snmp authenticate traps
Command: disable snmp authenticate traps
Success!
DGS-1100-06/ME:5#
config syslocation
Purpose
To enter a description of the location of the Switch.
Syntax
config syslocation <string 20>
Description
The config syslocation command enters a description of the
location of the Switch. A maximum of 20 characters can be used.
Parameters
<string 20> - A maximum of 20 characters is allowed.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the Switch location for ‘HQ5F’: