D-Link DGS-1100-06/ME - Config Lldp Ports

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
242
system_capabilities}] [enable | disable]
Description
The config lldp ports basic TLVs command defines if lldp will
advertise the switch’s basic TLVs the command is per port on the
switch.
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
Basic TLVs:
all – Advertisement of all the basic TLVs
port description – Advertisement of Port description
system name – Advertisement of system name
system description – Advertisement of System description
system capabilities – Advertisement of system capabilities
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP Basis TLVs
DGS-1100-06/ME:5#config lldp ports 1 basic_tlvs all enable
Command: config lldp ports 1 basic_tlvs all enable
Success!
DGS-1100-06/ME:5#
config lldp ports
Purpose
To define LLDP management basic TLVs advertisement on a port or ports.
Syntax
config lldp ports [<portlist>|all] dot3_tlvs [all | link aggregation |
mac_phy_configuration_status | maximum_frame_size] [enable |
disable]
Description
The config lldp ports dot3 TLVs command defines if lldp will advertise the
mac_phy_configuration_status the command is per port on the switch.
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
dot3_tlvs – defines if the advertisement is enabled or disabled. The possible
values are: link_aggregation, mac_phy_configuration_status,
maximum_frame_size or all.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP mac_phy_configuration status:
DGS-1100-06/ME:5#config lldp ports 2 dot3_tlvs mac_phy_configuration_status
enable
Command: config lldp ports 2 dot3_tlvsmac_phy_configuration_status enable
Success!
DGS-1100-06/ME:5#
config lldp ports
Purpose
To define LLDP management basic TLVs advertisement on a port or ports.