D-Link DGS-1100-06/ME - Show Ethernet_Oam Ports (Configuration)

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
257
mode.
Initiating Loopback – The local port has sent the start remote
loopback request to the peer and is waiting for response.
Remote Loopback – This indicates that both the local and
remote ports entered the loopback mode. Any non-OAM packet
received in the local port will be dropped.
Local Loopback – This indicates that both the local and remote
ports entered the loopback mode. The local port is doing the
loopback. Any non-OAM packets received on the port will be sent
back to the same port.
Terminate Loopback - The port is stopping loopback on the port.
Parameters
[all | <portlist>] – Specifies a range of ports or all ports to display
status.
Restrictions
None.
Example usage:
To show OAM control and status information on port 1:
DGS-1100-06/ME:5# show ethernet_oam ports 1 status
Command: show ethernet_oam ports 1 status
Port 1
Local Client
-----------------------------------------------------------
OAM : Enabled
Mode : Passive
Max OAMPDU : 1518 Bytes
Remote Loopback : Support
Unidirection : Not Supported
Link Monitoring : Support
Variable Request : Support
PDU Revision : 0
Operation Status : Disabled
Loopback Status : No Loopback
DGS-1100-06/ME:5#
show ethernet_oam ports (configuration)
Purpose
Used to display Ethernet OAM configuration per port.
Syntax
show ethernet_oam ports [all | <portlist>] configuration
Description
The show ethernet_oam ports command is used to view Ethernet
OAM configurations for ports.
Parameters
[all | <portlist>] – Specifies a range of ports or all ports to display
status.
Restrictions
None.
Example usage: