D-Link DGS-1100-06/ME - Config Ethernet_Oam Ports (Mode); Config Ethernet_Oam Ports (State)

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
249
config ethernet_oam ports (mode)
Purpose
Used to configure Ethernet OAM mode for ports.
Syntax
config ethernet_oam ports [all | <portlist>] mode [active |
passive]
Description
The config ethernet_oam ports command is used to configure
Ethernet OAM for ports to operate in active or passive mode.
Parameters
The command is used to configure Ethernet OAM for ports to
operate in active or passive mode.
Port configured in active mode:
(1) Initiate the exchange of Information OAMPDUs as defined by the
discovery state diagram.
(2) Active port is permitted to send any OAMPDU while connected to
a remote OAM peer entity in active mode.
(3) Active port operates in a limited respect if the remote OAM entity
is operating in passive mode.
(4) Active port should not respond to OAM remote loopback
commands and variable requests from a passive peer.
Port configured in passive mode:
(1) Do not initiate the discovery process
(2) React to the initiation of the Discovery process by the remote.
This eliminates the possibility of passive-to-passive links.
(3) Shall not send Variable request or loopback Control OAMPDUs”
for describe the active and passive mode.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure port 1 OAM mode to passive:
DGS-1100-06/ME:5# config ethernet_oam ports 1 mode passive
Command: config ethernet_oam ports 1 mode passive
Success!
DGS-1100-06/ME:5#
config ethernet_oam ports (state)
Purpose
Used to enable or disable Ethernet OAM per port.
Syntax
config ethernet_oam ports [all | <portlist>] state [enable |
disable]
Description
The config ethernet_oam ports command is used to enable or
disable Ethernet OAM function on a per port basis.
Enabling OAM initiates OAM discovery on a port. When OAM is enabled
on a port in active mode, that port will initiate discovery; if the port is not
OAM enabled, the port will not participate in the discovery process.
Parameters
[all | <portlist>] – Specifies a range of ports or all ports to be
configured.
state [enable | disable] – Specify to enable or disable the OAM
function for the listed ports. The default state is disabled.