D-Link DGS-1100-06/ME - Delete Authen Server_Group

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
228
server host but, remember that RADIUS is separate entities and are
not compatible with each other. The maximum supported number of
server group is 16.
Parameters
<string 15> – Defines the authentication group name as a string of
up to 15 alphanumeric characters.
<ipaddr> – The IPv4 address of the remote server group the user
wishes to alter.
ipv6address <ipv6addr> – The IPv6 address of the remote server
group the user wishes to alter.
[add | delete] –Specifies the authentication server host will be add or
deleted of the server group.
protocol radius – Specifies that the server host utilizes the RADIUS
protocol.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure a RADIUS authentication server group:
DGS-1100-06/ME:5#config authen server_group dlinkgroup add server_host
10.1.1.121 protocol radius
Command: config authen server_group dlinkgroup add server_host 10.1.1.121
protocol radius
Success.
DGS-1100-06/ME:5#
delete authen server_group
Purpose
To delete a user-defined authentication server host.
Syntax
delete authen server_group <string 15>
Description
The delete authen server_ group command deletes a user-defined
authentication server group previously created on the Switch.
Parameters
<string 15> –Specifies the authentication server group name to be
deleted.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To delete a user-defined rd1 authentication server group:
DGS-1100-06/ME:5#delete authen server_group dlinkgroup
Command: delete authen server_group dlinkgroup
Success.
DGS-1100-06/ME:5#