D-Link DGS-1100-06/ME - Config Ethernet_Oam Ports (Remote Loopback); Config Ethernet_Oam Ports (Received Remote Loopback)

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
254
config ethernet_oam ports (remote loopback)
Purpose
Used to start or stop Ethernet OAM remote loopback mode for the
remote peer of the port.
Syntax
config ethernet_oam ports [all | <portlist>] remote_loopback
[start | stop]
Description
The config ethernet_oam ports command is used to start or stop
the remote peer to enter Ethernet OAM remote loopback mode.
To start the remote peer to enter remote loopback mode, the port
must be in active mode and the OAM connection established.
If the local client is already in remote loopback mode, then the
command cannot be applied.
Parameters
[all | <portlist>] – Specifies a range of ports or all ports to be
configured.
remote_loopback [start | stop] – If start is specified, a request is sent
to the remote peer to change to remote loopback mode. If stop is
specified, a request is sent to the remote peer to change to normal
operation mode.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To start remote loopback on port 1 of unit 1:
DGS-1100-06/ME:5# config ethernet_oam ports 1 remote_loopback start
Command: config ethernet_oam ports 1 remote_loopback start
Success!
DGS-1100-06/ME:5#
config ethernet_oam ports (received remote loopback)
Purpose
Used to configure the method to process the received Ethernet OAM
remote loopback command.
Syntax
config ethernet_oam ports [all | <portlist>]
received_remote_loopback [process | ignore]
Description
The config ethernet_oam ports command is used to configure the
client to process or to ignore a received Ethernet OAM remote
loopback command.
In remote loopback mode, user traffic is not forwarded on the port. If
ignore is specified for received_remote_loopback, the specified port
will ignore all requests to transition to remote loopback mode and
prevent the Switch from entering remote loopback mode, thus it
continues to process user traffic regardless.
Parameters
[all | <portlist>] – Specifies a range of ports or all ports to be
configured.
received_remote_loopback [process | ignore] – Specify whether to
process or ignore the received Ethernet OAM remote loopback
command. The default method is “ignore”.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage: