D-Link DGS-1100-06/ME - Disable Snmp Traps; Show Snmp Traps

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
55
Command: enable snmp traps
Success!
DGS-1100-06/ME:5#
disable snmp traps
Purpose
To disable SNMP trap support on the Switch.
Syntax
disable snmp traps
Description
The disable snmp traps command disables SNMP trap support on
the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To prevent SNMP traps from being sent from the Switch:
DGS-1100-06/ME:5#disable snmp traps
Command: disable snmp traps
Success!
DGS-1100-06/ME:5#
show snmp traps
Purpose
To display SNMP trap support status on the Switch.
Syntax
show snmp traps
Description
The show snmp traps command displays the SNMP trap support
status currently configured on the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To view the current SNMP trap support:
DGS-1100-06/ME:5#show snmp traps
Command: show snmp traps
SNMP Traps : Enable
SNMP Authentication Traps : Enable
System Device Bootup : Enable
Fiber Port Link Up / Link Down : Enable
Twisted Pair Port Link Up / Link Down : Enable
Port Security violation State : Enable
Loopback detection State : Enable
DGS-1100-06/ME:5#