D-Link DGS-1100-06/ME - Show Ethernet_Oam Ports (Statistics)

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
258
To show Ethernet OAM configuration on port 2:
DGS-1100-06/ME:5# show ethernet_oam ports 2 configuration
Command: show ethernet_oam ports 2 configuration
Port 2
-----------------------------------------------------------
OAM : Disabled
Mode : Active
Critical Event : Enabled
Remote Loopback OAMPDU : Not Processed
Symbol Error
Notify State : Enabled
Window : 625000000 milliseconds
Threshold : 1 Errored Symbol
Frame Error
Notify State : Enabled
Window : 10 milliseconds
Threshold : 1 Errored Frame
Frame Period Error
Notify State : Enabled
Window : 10000000 Frames
Threshold : 1 Errored Frame
Frame Seconds Error
Notify State : Enabled
Window : 100 milliseconds
Threshold : 1 Errored Seconds
DGS-1100-06/ME:5#
show ethernet_oam ports (statistics)
Purpose
Used to display Ethernet OAM statistics for ports.
Syntax
show ethernet_oam ports [all | <portlist>] statistics
Description
The show ethernet_oam ports command is used to display
Ethernet OAM ports statistics information.
Parameters
[all | <portlist>] – Specifies a range of ports or all ports to display
status.
Restrictions
None.
Example usage: