D-Link DGS-1100-06/ME - Show Snmp Host; Create Snmp V6 Host

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
52
DGS-1100-06/ME:5#
show snmp host
Purpose
To display the recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
show snmp host {<ipaddr>}
Description
The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
designated as recipients of SNMP traps generated by the Switch’s
SNMP agent.
Parameters
<ipaddr> − The IP address of a remote SNMP manager that
receives SNMP traps generated by the Switch’s SNMP agent.
Restrictions
None.
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS-1100-06/ME:5#show snmp host
Command: show snmp host
SNMP Host Table
(Maximum Entries : 10)
Host IP Address SNMP Version Community Name/SNMPv3 User Name
------------------------ --------------------- -------------------------------------------------------
10.90.90.22 V3-NoAuthNoPriv dlink
Total Entries : 1
DGS-1100-06/ME:5#
create snmp v6host
Purpose
To create a recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
create snmp v6host <ip6_addr> [v1 <username 32> | v2c
<username 32> | v3 [noauth_nopriv | auth_nopriv | auth_priv]
<username 32>] {InterfaceName <string 20>}
Description
The create snmp v6host command creates a recipient of SNMP
traps generated by the Switch’s SNMP agent.
Parameters
<ipv6_addr> − The IPv6 address of the remote management station
to serve as the SNMP host for the Switch.
v1 – Specifies that SNMP version 1 is to be used. The Simple
Network Management Protocol (SNMP), version 1, is a network
management protocol that provides a means to monitor and control
network devices.
v2c – Specifies that SNMP version 2c is to be used. The SNMP v2c
supports both centralized and distributed network management
strategies. It includes improvements in the Structure of Management
Information (SMI) and adds some security features.