DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
229
To view a user-defined authentication server group.
show authen server_group {<string 15>}
The show authen server_ group command displays user-defined
authentication server groups previously created on the Switch.
The following parameters are displayed:
Group Name – The name of the server group.
IP Address – The IP address of the authentication server group.
Protocol – The protocol used by the server group.
Example usage:
To view authenticaion server hosts currently set on the Switch:
DGS-1100-06/ME:5# show authen server_group
Command: show authen server_group
(1) Group Name: linkgroup
(No servers in this group)
(2) Group Name: radius
IP Address: 3000::
Protocol: radius
IP Address: 10.1.1.121
Protocol: radius
Total Entries : 2
DGS-1100-06/ME:5#
To promote user level privileges to administrator level privileges.
The enable admin command enables a user to be granted
administrative privileges on to the Switch. After logging on to the
Switch, users have only ‘user’ level privileges. To gain access to
administrator level privileges, the user may enter this command. The
system then prompts for an authentication password. Possible
authentication methods for this function include TACACS, RADIUS,
user defined server groups, local enable (local account on the
To Next Page
Loading...
