DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
243
config lldp ports [<portlist>|all] dot1_tlv_pvid [disable | enable]
The config lldp ports dot1 TLVs command defines if lldp will advertise the
mac_phy_configuration_status the command is per port on the switch.
[<portlist> | all] – Specify a port or ports to be configured.
[enable | disable] - Defines if the advertisement is enabled or disabled.
Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP TLV PVID:
DGS-1100-06/ME:5#config lldp ports all dot1_tlv_pvid disable
Command: config lldp ports all dot1_tlv_pvid disable
Success!
DGS-1100-06/ME:5#
To define LLDP management basic TLVs advertisement on a port or ports.
config lldp ports [<portlist>|all] dot1_tlv_protocol_identity [all | eapol |
gvrp | lacp | stp][disable | enable]
The config lldp ports dot1 TLVs command defines if lldp will advertise the
mac_phy_configuration_status the command is per port on the switch.
[<portlist> | all] – Specify a port or ports to be configured.
dot1_tlv_protocol_identity − Defines if the advertisement is enabled or
disabled. The possible values are: eapol, gvrp, lacp, stp or all.
Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP ports configuration status:
DGS-1100-06/ME:5#config lldp ports all dot1_tlv_protocol_identity eapol enable
Command: config lldp ports all dot1_tlv_protocol_identity eapol enable
Success!
DGS-1100-06/ME:5#
To define LLDP management basic TLVs advertisement on a port or ports.
config lldp ports [<portlist>|all] dot1_tlv_vlan_name [vlan <vlan_name
32> | vlanid <vidlist>] [disable | enable]
The config lldp ports dot1 TLVs command defines lldp admin status per
port on the switch.
[<portlist> | all] – Specify a port or ports to be configured.
vlan <vlan_name 32> –The name of the VLAN to be configured.
dot1_tlv_vlan_name − Defines if the advertisement is enabled or disabled.
To Next Page
Loading...
