D-Link DGS-1100-06/ME - Basic Switch Commands

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
7
4
BASIC SWITCH COMMANDS
The Basic Switch commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable password
encryption
disable password
encryption
create account
[admin | operator | user] <username 15>
config account
<username 15>
show account
delete account
<username 15>
save account
show session
show switch
enable web
{<tcp_port_number 1-65535>}
disable web
enable autoconfig
disable autoconfig
show autoconfig
show config
[[config_in_nvram config_id <value 1-2>] | current_config] [begin | exclude]
<string 80>
enable auto learning
disable auto learning
enable jumbo_frame
disable jumbo_frame
show jumbo_frame
save
{[config config_id <value 1-2> | log | account]}
reboot
reset
{[config | system | account | password]} {force_agree}
logout
ping
<ipaddr> {times <value 1-255> | timeout <sec 1-99> | size <short 0-2080>}
ping6
<ipv6_addr> {frequency <sec 0-86400> | size <value 1-1522> | source_ip
<ipv6_addr> | timeout <sec 1-99> | times <value 1-255>}
enable telnet