D-Link DGS-1100-06/ME - Config 802.1 X Auth_Mode; Create 802.1 X Guest_Vlan

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
182
Syntax
show radius
Description
The show radius command displays the current RADIUS
configurations on the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To display RADIUS settings on the Switch:
DGS-1100-06/ME:5#show radius
Command: show radius
Index Ip Address Auth-Port Acct-Port Timeout Retransmit Key
(secs)
----- ---------------- --------- ---------- --------- --------------- ------
1 10.48.74.121 1812 1813 5 10 dlink
Total Entries : 1
Success!
DGS-1100-06/ME:5#
config 802.1x auth_mode
Purpose
To configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode [port_based | mac_based]
Description
The config 802.1x auth_mode command enables either the port-
based or MAC-based 802.1x authentication feature on the Switch.
Parameters
[port_based | mac_based] – Specifies whether 802.1x
authentication is by port or MAC address.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure 802.1x authentication by port address:
DGS-1100-06/ME:5#config 802.1x auth_mode port_based
Command: config 802.1x auth_mode port_based
Success!
DGS-1100-06/ME:5#
create 802.1x guest_vlan
Purpose
Enables network access to a Guest VLAN.
Syntax
create 802.1x guest vlan <vlan_name 32>