D-Link DGS-1100-06/ME - Config 802.1 X Capability Ports; Config 802.1 X Fwd_Pdu System

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
186
DGS-1100-06/ME:5#delete 802.1x user dlink
Command: delete 802.1x user dlink
Success!
DGS-1100-06/ME:5#
config 802.1x capability ports
Purpose
Defines a port or range of ports to be members of the 802.1x.
Syntax
config 802.1x capability ports [<portlist> | all] [authenticator |
none]
Description
Th config 802.1x capability ports is used to configure the
capability for the 802.1x on the Switch.
Parameters
<portlist> – A port or range of ports to be configured to the 802.1x
capability.
all – Indicates all ports to be configured to the 802.1x capability.
[authenticator | none] – Specifies the 802.1x capability port to be
authenticator or none.
Restrictions
Only Administrator or operator–level users can issue this command.
Example usage:
To configure capability ports to the 802.1x on the Switch:
DGS-1100-06/ME:5#config 802.1x capability ports all authenticator
Command: config 802.1x capability ports all authenticator
Success!
DGS-1100-06/ME:5#
config 802.1x fwd_pdu system
Purpose
Used to enable or disable the forwarding of EAPOL on the Switch.
Syntax
config 802.1x fwd_pdu system [enable | disable]
Description
Th config 802.1x fwd_pdu system is used to enable or disable the
forwarding of EAPOL on the Switch.
Parameters
[enable | disable] – Enables or disables the forwarding of EAPOL
PDU.
Restrictions
Only Administrator or operator–level users can issue this command.
Example usage:
To configure forwarding of EAPOL PDU system state enable: