D-Link DGS-1100-06/ME - Config Admin Local_Enable

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
230
Switch), or no authentication (none). Because TACACS does not
support the enable function, the user must create a special account
on the server host which has the username ‘enable’, and a
password configured by the administrator that will support the
‘enable’ function. This function becomes inoperable when the
authentication policy is disabled.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable administrator privileges on the Switch:
DGS-1100-06/ME:5#enable admin
Command: enable admin
Success!
DGS-1100-06/ME:5#
config admin local_enable
Purpose
To configure the local_enable password for administrator level
privileges.
Syntax
config admin local_enable
Description
The config admin local_enable command changes the locally
enabled password for the local_enable admin command. When a
user chooses the ‘local_enable’ method to promote user level
privileges to administrator privileges, the user is prompted to enter
the password configured here.
After entering the config admin local_enable command, the user is
prompted to enter the old password, then a new password in a string
of no more than 15 alphanumeric characters, and finally prompted to
enter the new password again for confirmation. See the example
below.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the password for the ‘local_enable’ authentication method:
DGS-1100-06/ME:5#config admin local_enable
Command: config admin local_enable
Enter the old password:
Enter the case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DGS-1100-06/ME:5#