D-Link DGS-1100-06/ME - Show Qos Mode; Config Cos Ipv6_Tc_Mapping

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
109
Syntax
config qos mode [802.1p | dscp | portbased]
Description
The config qos mode command is used to configure the QoS mode
on the Switch.
Parameters
[802.1p | dscp | portbased] – Specifies the QoS mode to be 802.1p,
dscp or portbased.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure the QoS mode to be portbased on the Switch:
DGS-1100-06/ME:5# config qos mode portbased
Command: config qos mode portbased
Success
DGS-1100-06/ME:5#
show qos mode
Purpose
To display the QoS mode.
Syntax
show qos mode
Description
The show qos mode command is used to display the QoS mode on
the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To display the QoS mode on the Switch:
DGS-1100-06/ME:5# show qos mode
Command: show qos mode
Qos mode : portbase
DGS-1100-06/ME:5#
config cos ipv6_tc_mapping
Purpose
To configure the CoS IPv6 TC mapping method.
Syntax
config cos ipv6_tc_mapping trafficclass <class_id 0-255>
priority [high | highest | low | medium]
Description
The config cos ipv6_tc_mapping command is used to configure
the CoS IPv6 mapping method on the Switch.
Parameters
<class_id 0-255> - Specifies the IPv6 traffic class to be mapped.
The range is 0 to 255.
priority [high | highest | low | medium] - Specifies the priority of the
ipv6 mapping priority queue.