D-Link DGS-1100-06/ME - Show Lldp Mgt_Addr; Show Lldp Statistics

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
244
vlanid <vidlist> –The vid of the VLAN to be configured.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP mac_phy_configuration status:
DGS-1100-06/ME:5#config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Command: config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Success!
DGS-1100-06/ME:5#
show lldp mgt_addr
Purpose
To display the Link Layer Discovery Protocol (LLDP) configuration
that is advertised from a specific port.
Syntax
show lldp mgt_addr {ipv4 <ipaddr> | ipv6 <ipv6addr>}
Description
The show lldp mgt_addr command displays the information
regarding the IPv4 or IPv6 address.
Parameters
ipv4 <ipaddr> | ipv6 <ipv6addr> – Specifies the lldp IPv4 or IPv6
address to be displayed.
Restrictions
None.
Example usage:
To show the LLDP management address advertisement:
DGS-1100-06/ME:5#show lldp mgt_addr
Command: show lldp mgt_addr
Address : 1
------------------------------------------------------------------------------
Subtype : IPv6
Address : fe80::2c8:e7ff:fe88:5c95
IF Type : ifIndex
OID : 1.3.6.1.2.1.2.2.1.1
Advertising Ports : (NONE)
Total Address : 1
DGS-1100-06/ME:5#
show lldp statistics
Purpose
To display the Link Layer Discovery Protocol (LLDP) statistics for the
specified ports.
Syntax
show lldp statistics {ports <portlist>}
Description
The show lldp statistics command displays the statistics of LLDP
on the Switch.
Parameters
{ports <portlist> – Specifies the ports to be displayed.
Restrictions
None.