D-Link DGS-1100-06/ME - Delete Authen Server_Host

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
225
packets to a remote RADIUS server host on a remote host. The
RADIUS server host then verifies or denies the request and returns
the appropriate message to the Switch. More than one
authentication protocol can be run on the same physical server host
but, remember that RADIUS is separate entities and are not
compatible with each other. The maximum supported number of
server hosts is 16.
Parameters
<ipaddr> – The IPv4 address of the remote server host the user
wishes to alter.
ipv6address<ipv6addr> – The IPv6 address of the remote server
host the user wishes to alter
protocol radius – Specifies that the server host utilizes the RADIUS
protocol.
port <int 1-65535> – The virtual port number of the authentication
protocol on a server host. The value must be between 1 and 65535.
The default port numbers are 1812 and 1813 for RADIUS servers
but the user may set a unique port number for higher security.
key [<string 254> | none] – The authentication key to be shared with
a configured RADIUS server only. The value is a string of up to 254
alphanumeric characters, or none.
timeout <int 1-255> – The time in seconds the Switch waits for the
server host to reply to an authentication request. The default value is
5 seconds.
retransmit <int 1-255> – The number of times the device resends an
authentication request when the server does not respond. The value
is between 1 and 255.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure a RADIUS authentication server host, with port number 4321, a timeout value of 12 seconds and a
retransmit count of 4.
DGS-1100-06/ME:5# config authen server_host 10.1.1.121 protocol radius port
4321 timeout 12 retransmit 4
Command: config authen server_host 10.1.1.121 protocol radius port 4321
timeout 12 retransmit 4
Success.
DGS-1100-06/ME:5#
delete authen server_host
Purpose
To delete a user-defined authentication server host.
Syntax
delete authen server_host [<ipaddr> | ipv6address <ipv6addr>]
protocol radius
Description
The delete authen server_host command deletes a user-defined
authentication server host previously created on the Switch.
Parameters
<ipaddr> - The IPv4 address of the remote server host to be deleted.
ipv6address <ipv6addr> - The IPv6 address of the remote server
host to be deleted.