DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
33
7
LOOPBACK DETECTION COMMANDS
The Loopback Detection commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
[<portlist> | all] [enable | disable]
interval_time <value 1-32767> lbd_recover_time [0 | <value 60-1000000>]
{ports [<portlist> | all]}
Each command is listed in detail, as follows:
To enable the loop back detection on the Switch.
The enable loopdetect command enables the loop back detection
on the Switch.
Only administrator or operate-level users can issue this command.
Example usage:
To enable the loopback detection feature on the Switch:
DGS-1100-06/ME:5#enable loopdetect
Command: enable loopdetect
Success!
DGS-1100-06/ME:5#
To disable the loop back detection on the Switch.
The disable loopdetect command disables the loop back detection
on the Switch.
Only administrator or operate-level users can issue this command.
To Next Page
Loading...
