D-Link DGS-1100-06/ME - Create Authen Server_Group; Config Authen Server_Group

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
227
DGS-1100-06/ME:5# show authen server_host
Command: show authen server_host
IP Address: 10.1.1.121
Protocol: radius
Port: 4321
Timeout: 12
Retransmit: 4
Key:
Total Entries : 1
DGS-1100-06/ME:5#
create authen server_group
Purpose
To create an authentication server host.
Syntax
create authen server_group <string 15>
Description
The create authen server_ group command creates an
authentication server group for the protocols on the Switch.
Parameters
<string 15> – Defines the authentication group name as a string of
up to 15 alphanumeric characters.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To create a server group “dlinkgroup”:
DGS-1100-06/ME:5#create authen server_group dlinkgroup
Command: create authen server_group dlinkgroup
Success.
DGS-1100-06/ME:5#
config authen server_group
Purpose
To configure a user-defined authentication server host.
Syntax
config authen server_group [<string 15> | radius] [add | delete]
server_host [<ipaddr> | ipv6address <ipv6addr>] protocol
radius
Description
The config authen server_ group command configures a user-
defined authentication server group for the RADIUS security
protocols on the Switch. When a user attempts to access the Switch
with the authentication protocol enabled, the Switch sends
authentication packets to a remote RADIUS server group on a
remote host. The RADIUS server group then verifies or denies the
request and returns the appropriate message to the Switch. More
than one authentication protocol can be run on the same physical