D-Link DGS-1100-06/ME - Disable Snmp; Enable Snmp Fiber_Port_Link Traps

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
58
Description
The enable snmp command enables SNMP support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable SNMP support on the Switch:
DGS-1100-06/ME:5#enable snmp
Command: enable snmp
Success!
DGS-1100-06/ME:5#
disable snmp
Purpose
To disable SNMP support.
Syntax
disable snmp
Description
The disable snmp command enables SNMP support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP support on the Switch:
DGS-1100-06/ME:5#disable snmp
Command: disable snmp
Success!
DGS-1100-06/ME:5#
enable snmp fiber_port_link traps
Purpose
To enable SNMP fiber port link traps support on the Switch.
Syntax
enable snmp fiber_port_link traps
Description
The enable snmp fiber_port_link traps command enables SNMP
fiber port link traps support on the Switch. After enables the SNMP
fiber port link traps support, the Switch will send out a trap to the
SNMP manage host when the fiber port is link up or link down.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command
Example usage:
To enable SNMP fiber port link traps support on the Switch:
DGS-1100-06/ME:5#enable snmp fiber_port_link traps
Command: enable snmp fiber_port_link traps