D-Link DGS-1100-06/ME - Ethernet Oam Commands

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
248
38
ETHERNET OAM COMMANDS
Ethernet OAM (Operations, Administration, and Maintenance) is a data link layer protocol which
provides network administrators the ability to monitor the health of the network and quickly determine
the location of failing links or fault conditions on point-to-point and emulated point-to-point Ethernet link.
The Ethernet OAM commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config ethernet_oam
ports (mode)
[all | <portlist>] mode [active | passive]
config ethernet_oam
ports (state)
[all | <portlist>] state [enable | disable]
config ethernet_oam
ports (link monitor error
symbol)
[all | <portlist>] link_monitor error_symbol {threshold <integer 1-4294967295> |
window < integer 1000-60000> | notify_state [enable | disable]}
config ethernet_oam
ports (link monitor error
frame)
[all | <portlist>] link_monitor error_frame {threshold <integer 1-4294967295> |
window < integer 1000-60000> | notify_state [enable | disable]}
config ethernet_oam
ports (link monitor error
frame seconds)
[all | <portlist>] link_monitor error_frame_seconds {threshold < integer 1-
4294967295> | window < integer 1000-60000> | notify_state [ enable | disable]}
config ethernet_oam
ports (link monitor error
frame period)
[all | <portlist>] link_monitor error_frame_period {threshold < integer 1-
4294967295> | window < integer 148810-100000000> | notify_state [ enable |
disable]}
config ethernet_oam
ports (remote
loopback)
[all | <portlist>] remote_loopback [start | stop]
config ethernet_oam
ports (received remote
loopback)
[all | <portlist>] received_remote_loopback [process | ignore]
show ethernet_oam
ports (status)
[all | <portlist>] status
show ethernet_oam
ports (configuration)
[all | <portlist>] configuration
show ethernet_oam
ports (statistics)
[all | <portlist>] statistics
show ethernet_oam
ports (event log)
[all | <portlist>] event_log {index <portlist>}
clear ethernet_oam
ports
[all | <portlist>] [event_log| statistics]
Each command is listed in detail, as follows: