D-Link DGS-1100-06/ME - Show Authen Server_Host

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
226
protocol radius – Specifies that the server host utilizes the RADIUS
protocol.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To delete a user-defined RADIUS authentication server host:
DGS-1100-06/ME:5#delete authen server_host 10.1.1.121 protocol radius
Command: delete authen server_host 10.1.1.121 protocol radius
Success.
DGS-1100-06/ME:5#
show authen server_host
Purpose
To view a user-defined authentication server host.
Syntax
show authen server_host
Description
The show authen server_host command displays user-defined
authentication server hosts previously created on the Switch.
The following parameters are displayed:
IP Address – The IPv4 or IPv6 address of the authentication server
host.
Protocol – The protocol used by the server host.
Port – The virtual port number on the server host. The default value
is 49.
Timeout - The time in seconds the Switch waits for the server host to
reply to an authentication request.
Retransmit - The value in the retransmit field denotes how many
times the device resends an authentication request.
Key - Authentication key to be shared with a configured RADIUS
server only.
Parameters
None.
Restrictions
None.
Example usage:
To view authenticaion server hosts currently set on the Switch: