D-Link DGS-1100-06/ME - Show Jumbo_Frame; Save

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
18
Command: disable jumbo_frame
Success.
DGS-1100-06/ME:5#
show jumbo_frame
Purpose
To display the jumbo frame configuration.
Syntax
show jumbo_frame
Description
The show jumbo_frame command displays the jumbo frame
configuration.
Parameters
None.
Restrictions
None.
Example usage:
To show the jumbo_frames configuration status on the device:
DGS-1100-06/ME:5# show jumbo_frame
Command: show jumbo_frame
Jumbo frame is enable.
Success
DGS-1100-06/ME:5#
save
Purpose
To save changes in the Switch’s configuration to non-volatile RAM.
Syntax
save {[config config_id <value 1-2> | log | account]}
Description
The save command used to enter the current switch configuration
into non-volatile RAM. The saved switch configuration will be loaded
into the Switch’s memory each time the Switch is restarted.
Parameters
config – Used to save the current configuration to a file.
config_id <value 1-2> - Specifies which cfg file ID if cfg ID is not
specified, it refers to the boot_up CFG file.
log – Used to save the current log to a file. The log file cannot be
deleted.
account – Used to save the account to a file.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non-volatile RAM: