DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
81
To disable DHCPv6 Relay function on the Switch
The disable dhcpv6_relay command is used to disable the
DHCPv6 relay global state on the Switch.
Only Administrator or operate-level users can issue this command.
Example usage:
To disable DHCPv6 Relay on the Switch:
DGS-1100-06/ME:5#disable dhcpv6_relay
Command: disable dhcpv6_relay
Success!
DGS-1100-06/ME:5#
To display the current DHCPv6 relay configuration.
show dhcpv6_relay {ipif system}
The show dhcpv6_relay command displays the current DHCPv6
relay configuration of all interfaces, or if an IP interface name is
specified, the DHCPv6 relay configuration for that IP interface.
Example usage:
To display DHCPv6 Relay settings:
DGS-1100-06/ME:5#show dhcpv6_relay ipif System
Command: show dhcpv6_relay ipif System
DHCPv6 Relay Global State : Enabled
DHCPv6 Hops Count Limit : 4
---------------------------------------------------------------
IP Interface : Syetem
Server Address :
Total Entries : 0
DGS-1100-06/ME:5#
To Next Page
Loading...
