D-Link DGS-1100-06/ME - Port Priority Commands; Config Port_Priority; Show Port_Priority

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
190
28
PORT PRIORITY COMMANDS
The Port Priority commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config port_ priority
[<portlist> | all] priority [highest | low | medium | high]
show port_priority
{ all | <portlist> }
Each command is listed in detail, as follows:
config port_priority
Purpose
To configure port priority settings.
Syntax
config port_priority [<portlist> | all] priority [highest | low |
medium | high]
Description
The config port_ priority command configures port priority settings
for specific ports.
Parameters
{all | <portlist>} – Specifies all ports or range of ports to be
configured.
[highest | low | medium | high] – Specifies the priority of ports
mapping priority queue.
Restrictions
Only administrator or operator-level users can issue this command
Example usage:
To configure port priority:
DGS-1100-06/ME:5# config port_priority all priority highest
Command: config port_priority all priority highest
Success
DGS-1100-06/ME:5#
show port_priority
Purpose
To display the current port priority configuration.
Syntax
show port_priority { all | <portlist> }
Description
The show port_ priority command displays port priority information
for the Switch’s ports.
Parameters
{all | <portlist>} – All ports or range of ports whose settings are to be
displayed.
Restrictions
None.
Example usage: