D-Link DGS-1100-06/ME - Vlan Commands; Create Vlan

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
124
19
VLAN COMMANDS
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
create vlan
<string 20> {tag <int 2-4094>}
delete vlan
[<vlan_name 20> | vlanid <int 2-4094>]
config vlan
[<vlan_name 20> | vlanid <vlanid 1-4094>] [[add [tagged | untagged] | delete ]
<portlist>
config pvid
<int 1-4094> ports <portlist>
show vlan
{<int 1-4094>}
enable asymmetric_
vlan
disable
asymmetric_vlan
show asymmetric_vlan
enable management
vlan
disable management
vlan
config management
vlan
<string 32>
show management
vlan
show port_vlan pvid
Each command is listed in detail, as follows:
create vlan
Purpose
To create a VLAN on the Switch.
Syntax
create vlan <string 20> {tag <int 2-4094>}
Description
The create vlan command creates a VLAN on the Switch.
Parameters
<string 20> − The name of the VLAN to be created.
tag <int 2-4094> − The VLAN ID of the VLAN to be created. The
allowed values range from 2 to 4094.
Restrictions
Each VLAN name can be up to 32 characters. If the VLAN is not
given a tag, it will be a port-based VLAN.
Only administrator or operator-level users can issue this command.
Example usage:
To create a VLAN v1, tag 3: