DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
223
The config authen parameter attempt command provides user to
configure the authentication parameters on the Switch.
attemtp <integer 1-255> – Specifies the attempt of authentication
parameter on the Switch. The value range is between 1 and 255.
response_timout <integer 0-255> – Specifies the response timout of
authentication parameter on the Switch. The value range is between
0 and 255.
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the default method list for the command line interface:
DGS-1100-06/ME:5#config authen parameter attempt 10
Command: config authen parameter attempt 10
Success.
DGS-1100-06/ME:5#
To display authentication parameters for the various applications on
the Switch.
The show authen parameter command displays the authentication
parameter on the Switch.
Example usage:
To display the authentication parameters for all applications on the Switch:
DGS-1100-06/ME:5#show authen parameter
Command: show authen parameter
Response Timeout : 30 seconds
User Attempts : 10
DGS-1100-06/ME:5#
create authen server_host
To create an authentication server host.
create authen server_host [<ipaddr>| ipv6address <ipv6addr>]
protocol radius {port <int 1-65535> | key [<string 254> | none] |
timeout <int 1-255> | retransmit <int 1-255>}
The create authen server_host command creates an
authentication server host for the RADIUS security protocols on the
Switch. When a user attempts to access the Switch with
To Next Page
Loading...
