D-Link DGS-1100-06/ME - Enable Web; Disable Web

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
13
System up time : 0 days, 0 hrs, 20 min, 28 secs
System Time : 01/01/2012 00:20:30
System hardware version : A1
System firmware version : 1.00.008
System boot version : 1.00.000
System Protocol version : 2.001.004
System serial number : 1MB1733K0000A
MAC Address : 00-AE-B7-21-22-62
SNMP Status : Enabled
Port Mirroring : Disabled
802.1X Status : Disabled
Storm Control : Disabled
802.1Q Management VLAN : Disabled
Safeguard Engine : Enabled
IGMP Snooping : Disabled
DGS-1100-06/ME:5#
enable web
Purpose
To enable the HTTP-based management software on the Switch.
Syntax
enable web {<tcp_port_number 1-65535>}
Description
The enable web command enables the Web-based management
software on the Switch. The user can specify the TCP port number
the Switch uses to listen for Telnet requests.
Parameters
<tcp_port_number 1-65535> − The TCP port number. TCP ports are
numbered between 1 and 65535. The ‘well-known’ port for the Web-
based management software is 80.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable HTTP and configure the TCP port number to listen for Telnet requests:
DGS-1100-06/ME:5# enable web
Command: enable web
Success.
DGS-1100-06/ME:5#
disable web
Purpose
To disable the HTTP-based management software on the Switch.
Syntax
disable web
Description
The disable web command disables the Web-based management
software on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.