D-Link DGS-1100-06/ME - Config Time_Range

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
24
To disable telnet:
DGS-1100-06/ME:5#disable telnet
Command: disable telnet
Success.
DGS-1100-06/ME:5#
config time_range
Purpose
To configure the time range on the Switch..
Syntax
config time_range <range_name 20> [[hours start_time
<start_time 32> end_time <end_time 32> weekdays <daylist 32>
date from_day year <start_year 2011-2029> month <start_mth 1-
12> date <start_date 1-31> to_day year <end_year 2011-2029>
month <end_mth 1-12> date <end_date 1-31>] | delete]
Description
The config time_range command defines time ranges for access
lists. If the end time is earlier than the start time, the end time will
move to the following day
Parameters
<range_name 20> – Specifies the time range name. The range of
characters is 1 - 20.
start_time <start_time 32> – defines the time on which the time
range will start to be active.
end_time <end_time 32 >– defines the time on which the time range
will stop to be active.
weekdays <daylist 32> – defines the days of the week on which the
time range will be active.
<start_year 2011-2029 > – Specifies the time range start year.
<start_mth 1-12> – Specifies the time range start month.
<start_date 1-31> – Specifies the time range start date.
<end_year 2011-2029 > – Specifies the time range end year.
<end _mth 1-12> – Specifies the time range end month.
<end _date 1-31> – Specifies the time range end date.
delete – Delete the time range settings.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the time range on the Switch:
DGS-1100-06/ME:5# config time_range dd hours start_time 00:22 end_time
12:34 weekdays tue-fri date from_day year 2012 month 1 date 1 to_day year
2012 month 1 date 3
Command: config time_range dd hours start_time 00:22 end_time 12:34
weekdays tue-fri date from_day year 2012 month 1 date 1 to_day year 2012
month 1 date 3
Success!
DGS-1100-06/ME:5#