D-Link DGS-1100-06/ME - Enable Mld_Snooping; Disable Mld_Snooping; Config Mld_Snooping

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
156
Each command is listed in detail, as follows:
enable mld_snooping
Purpose
To enable MLD snooping on the Switch.
Syntax
enable mld snooping {forward_mcrouter only}
Description
The enable mld snooping command enables MLD snooping on the
Switch.
Parameters
forward_mcrouter only – Enableds the forwarding multicast router
only of MLD snooping.
Restrictions
Only administrator or operator–level users can issue this command.
Example usage:
To enable the MLD snooping:
DGS-1100-06/ME:5#enable mld_snooping
Command: enable mld_snooping
Success !
DGS-1100-06/ME:5#
disable mld_snooping
Purpose
To disable MLD snooping on the Switch.
Syntax
disable mld snooping {forward_mcrouter only}
Description
The disable mld snooping command disables MLD snooping on
the Switch.
Parameters
forward_mcrouter only - Disables the forwarding multicast router
only of MLD snooping.
Restrictions
Only administrator or operator–level users can issue this command.
Example usage:
To disable the MLD snooping:
DGS-1100-06/ME:5#disable mld_snooping
Command: disable mld_snooping
Success !
DGS-1100-06/ME:5#
config mld_snooping
Purpose
To configure mld snooping.
Syntax
config mld_snooping [vlan_name <string 20> | vlanid <vidlist> |
all] {fast_done [enable | disable] | host_timeout <sec 130-
1530255> | leave_timer <sec 1-25> | router_timeout <sec 60-
600> | state [enable | disable]}
Description
The config mld_snooping command defines mld snooping on the
VLAN.