D-Link DGS-1100-06/ME - Show Ethernet_Oam Ports (Event Log)

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
259
To show Ethernet OAM statistics on port 2:
DGS-1100-06/ME:5# show ethernet_oam ports 2 statistics
Command: show ethernet_oam ports 2 statistics
Port 2
------------------------------------------------------------------------
Information OAMPDU Tx : 0
Information OAMPDU Rx : 0
Unique Event Notification OAMPDU Tx : 0
Unique Event Notification OAMPDU Rx : 0
Duplicate Event Notification OAMPDU Tx: 0
Duplicate Event Notification OAMPDU Rx: 0
Loopback Control OAMPDU Tx : 0
Loopback Control OAMPDU Rx : 0
Variable Request OAMPDU Tx : 0
Variable Request OAMPDU Rx : 0
Variable Response OAMPDU Tx : 0
Variable Response OAMPDU Rx : 0
Organization Specific OAMPDUs Tx : 0
Organization Specific OAMPDUs Rx : 0
Unsupported OAMPDU Tx : 0
Unsupported OAMPDU Rx : 0
Frames Lost Due To OAM : 0
DGS-1100-06/ME:5#
show ethernet_oam ports (event log)
Purpose
Used to display Ethernet OAM event log.
Syntax
show ethernet_oam ports [all | <portlist>] event_log {index
<portlist>}
Description
The show ethernet_oam ports command is used to view ports
Ethernet OAM event log information. The Switch can buffer 1000
event logs. The event log is different from sys-log. It provides more
detailed information than sys-log. Each OAM event will be recorded
in both OAM event log and syslog. Specify an index to show a range
of events.
Parameters
[all | <portlist>] – Specifies a range of ports or all ports to display
status.
index <portlist> – Specifies an index range to display.
Restrictions
None.
Example usage: