D-Link DGS-1100-06/ME - Igmp Snooping Commands

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
140
23
IGMP SNOOPING COMMANDS
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
enable igmp_snooping
{forward_mcrouter_only}
disable igmp_snooping
{forward_mcrouter_only}
show igmp_snooping
{vlan <vlan_name 20>}
config igmp_snooping
[vlan_name <string 20> | vlanid <vidlist> | all] [host_timeout <sec 130-153025> |
router_timeout <sec 60-600> | leave_timer <sec 1-25> | fast_leave [enable |
disable] | state [enable | disable]]
config igmp_snooping
querier
[vlan_name <string 20> | vlanid <vidlist> | all] state [enable | disable]
{querier_version [IGMPv2 | IGMPv3] | last_member_query_interval <sec 1-25> |
max_response_time <sec 10-25> | query_interval <sec 60-600>}
config igmp_snooping
querier_selection
[vlan_name <string 20> | vlanid <vidlist> | all] state [enable | disable]
config igmp_snooping
robustness_variable
<integer 2-255>
create igmp_snooping
multicast_vlan
<vlan_name 32> <vlanid 2-4094>
config igmp_snooping
multicast_vlan
<vlan_name 32> [add | delete] [member_port <portlist> | source_port <portlist> |
tag_member_port <portlist>] state [enable | disable] {replace_source_ip [none |
<ipaddr>]}
delete igmp_snooping
multicast_vlan
[<vlan_name 32> | all]
config igmp_snooping
multicast_vlan_group
<vlan_name 32> [add | delete] ipv4_range <ipaddr>
config router_ports
[vlan_name <string 20> | vlanid <vidlist> | all] [add | delete] <portlist>
config igmp
access_authentication
ports
[<portlist> | all] state [enable | disable]
show igmp
access_authentication
ports
[<portlist> | all]
enable igmp_snooping
multicast_vlan
disable igmp_snooping
multicast_vlan
show igmp_snooping
multicast_vlan
<vlan_name 32>
show igmp_snooping
<vlan_name 32>