DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
15
Only Administrator-level users can issue this command. .
Example usage:
To stop the auto configuration function:
DGS-1100-06/ME:5# disable autoconfig
Command: disable autoconfig
Success.
DGS-1100-06/ME:5#
Used to display the current autoconfig status of the Switch.
The show autoconfig command is used to list the current status of
the auto configuration function.
Example usage:
To display the autoconfig status:
DGS-1100-06/ME:5# show autoconfig
Command: show autoconfig
Autoconfig State: Enabled
DGS-1100-06/ME:5#
To display the current or saved version of the configuration settings
of the Switch.
show config [[config_in_nvram config_id <value 1-2>] |
current_config] [begin | exclude] <string 80>
The show config command is used to list the current status of the
configuration settings of the Switch.
config_in_nvram config_id <value 1-2> − Display the system
configuration from NV-RAM.
current_config − Display system configuration from the DRAM
database, i.e. the current system setting.
[begin | exclude] − Display the configuration which is begined or
excluded.
<string 80> − Display the configuration which begin or exclude the
specified string. The maximum string is 80.
Example usage:
To display the autoconfig status:
To Next Page
Loading...
