D-Link DGS-1100-06/ME - Q-In-Q Commands; Enable Qinq; Disable Qinq

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
131
20
Q-IN-Q COMMANDS
The Link Aggregation commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
enable qinq
disable qinq
show qinq
{ports [<portlist> | all]}
config qinq ports
[<portlist> | all] [role [nni | uni] | outer_tpid <hex 0x1-0xffff>]
Each command is listed in detail, as follows:
enable qinq
Purpose
To enable the Q-in-Q mode.
Syntax
enable qinq
Description
The enable qinq command creates a used to enable the Q-in-Q
mode.
When Q-in-Q is enabled, all network port roles will be NNI port and
their outer TPID will be set to 88a8. All existing static VLANs will run
as SP-VLAN. All dynamically learned L2 address will be cleared.
The default setting of Q-in-Q is disabled.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable Q-in-Q:
DGS-1100-06/ME:5#enable qinq
Command: enable qinq
Success!
DGS-1100-06/ME:5#
disable qinq
Purpose
To disable the Q-in-Q mode.
Syntax
disable qinq
Description
The disable qinq command is used to disable the Q-in-Q mode.
All dynamically learned L2 address will be cleared. All dynamically
registered VLAN entries will be cleared. All existing SP-VLANs will