DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
204
Example usage:
To show IPv6 ND related configuration:
DGS-1100-06/ME:5# show ipv6 nd ipif System
Command: show ipv6 nd ipif System
Interface Name : System
NS Retransmit Time : 100(ms)
DGS-1100-06/ME:5#
Used to create IPv6 route entries to the Switch’s IP routing table.
create ipv6route default <ipv6addr>
This create ipv6route default command is used to create a primary
and backup IP route entry to the Switch’s IP routing table.
<ipv6addr> – Specify the IPv6 address to be crete.
Only Administrator or operator-level users can issue this command.
Example usage:
To add a single static IPv6 entry in IPv6 format:
DGS-1100-06/ME:5#create ipv6route default 3ffc::1
Command: create ipv6route default 3ffc::1
Success.
DGS-1100-06/ME:5#
Used to delete a static IPv6 route entry from the Switch’s IP routing
table.
This delete ipv6route default command will delete an existing static
IPv6 entry from the Switch’s IP routing table.
Only Administrator or operator-level users can issue this command.
Example usage:
To o delete a static IPv6 entry from the routing table:
To Next Page
Loading...
