D-Link DGS-1100-06/ME - Config Loopdetect Mode; Config Loopdetect Ports

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
34
Example usage:
To disable the loopback detection feature on the Switch:
DGS-1100-06/ME:5#disable loopdetect
Command: disable loopdetect
Success!
DGS-1100-06/ME:5#
config loopdetect mode
Purpose
To configure the loop back detection mode to be portbase or
vlanbase on the Switch.
Syntax
config loopdetect mode [portbase | vlanbase]
Description
The config loopdetect mode command configures loop back
detection mode to be portbase or vlanbase on the Switch.
Parameters
[portbase | vlanbase]] - Specifies the loopdetect mode to be
portbase or vlanbase.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To configure the loopback detection mode to be portabse on the Switch:
DGS-1100-06/ME:5#config loopdetect mode portbase
Command: config loopdetect mode portbase
Success!
DGS-1100-06/ME:5#
config loopdetect ports
Purpose
To configures the loop back detection to be enabled or disabled for
the specific ports on the Switch.
Syntax
config loopdetect ports [<portlist> | all] [enable | disable]
Description
The config loopdetect ports command configures the loop back
detection to be enabled or disabled for the specific ports on the
Switch.
Parameters
<portlist> − A port or range of ports to be configured.
all − All ports settings are to be configured.
[enabled | disabled] − Specifies the loop back detection is enabled or
disabled for the specified ports on the Switch.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To enable the loop back detection on the Switch:
DGS-1100-06/ME:5#config loopdetect ports all enable
Command: config loopdetect ports all enable