D-Link DGS-1100-06/ME - Show Duld Ports

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
32
Restrictions
None.
Example usage:
To display the configuration of port 3 on the Switch:
DGS-1100-06/ME:5# show ports 3
Command: show ports 3
Port State/ Settings Connection Address
Type MDI Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
----- ------ ---- -------------------------------- -------------------------------- ------------
3 Enabled 100M/Full/Enabled Link Down Enabled
MDI
DGS-1100-06/ME:5#
show duld ports
Purpose
To display the Switch’s Ethernet duld port settings.
Syntax
show duld ports {all | <portlist>}
Description
The show duld ports command displays the Switch’s Ethernet duld
port settings.
Parameters
{all | <portlist>} − Specifies all ports or range of ports to be
displayed.
Restrictions
None.
Example usage:
To display the Switch’s Ethernet duld port settings.
DGS-1100-06/ME:5# show duld ports
Command: show duld ports
port Admin State Oper Status Mode Link Status Discovery Time(Sec)
----- ----------------- ---------------- -------- ----------------- ----------------------------
1 Disabled Disabled Normal Unknown 5
2 Disabled Disabled Normal Unknown 5
3 Disabled Disabled Normal Unknown 5
4 Disabled Disabled Normal Unknown 5
5 Disabled Disabled Normal Unknown 5
6 Disabled Disabled Normal Unknown 5
DGS-1100-06/ME:5#