EasyManua.ls Logo

D-Link DGS-1100-06/ME - Enable Auto Learning; Disable Auto Learning

D-Link DGS-1100-06/ME
275 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
16
#---------------------------------------------------------------------------------------------------
# DGS-1100-06/ME Gigabit Ethernet Switch Configuration
#
# Firmware: Build 1.00.011
# Copyright(C) 2010 D-Link Corporation. All rights reserved.
#--------------------------------------------------------------------------------------------------
command-start
# Basic
config syslogintimeout 5
config sysgroupinterval 120
enable web 80
config arp_aging time 5
config fdb aging_time 300
enable telnet 23
# Vlan
disable asymmetric_vlan
create vlan default
config vlan vlanid 1 add untagged 1-6
config multicast filter 1 forward
config multicast filter 2 forward
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a ALL
enable auto learning
Purpose
To enable the MAC address auto learning on the switch.
Syntax
enable auto learning
Description
The enable auto learing command enables the MAC address auto
learning feature on the Switch.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable auto learning on the Switch:
DGS-1100-06/ME:5# enable auto learning
Command: enable auto learning
Success
DGS-1100-06/ME:5#
disable auto learning
Purpose
To disable the MAC address auto learning of the switch.
Syntax
disable auto learning

Table of Contents

Other manuals for D-Link DGS-1100-06/ME

Related product manuals