D-Link DGS-1100-06/ME - Show Utilization

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
85
Undersize 0 CRC Error 0
Oversize 0 Late Collision 0
Fragment 8 Excessive Collision 0
Jabber 0 Single Collision 0
Drop Pkts 0 Collision 0
DGS-1100-06/ME:5#
show utilization
Purpose
To display real-time port utilization statistics.
Syntax
show utilization [ports {<portlist>} | cpu | mem]
Description
The show utilization command displays the real-time utilization
statistics for ports in bits per second (bps) for the Switch, and for the
CPU in percentage..
Parameters
ports – Entering this parameter will display the current port utilization
of the Switch.
<portlist> – Specifies a range of ports to be displayed.
cpu – Entering this parameter will display the current CPU utilization
of the Switch.
mem – Entering this parameter will display the current memory
utilization of the Switch.
Restrictions
None.
To display the port 2 utilization statistics:
DGS-1100-06/ME:5#show utilization ports 2
Command: show utilization ports 2
2 0 0 0
Port TX/sec RX/sec Util
------ -------- ---------- ----
2 0 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
DGS-1100-06/ME:5#
To display the cpu utilization statistics:
DGS-1100-06/ME:5#show utilization cpu
Command: show utilization cpu
Five Seconds - 6 % One Minute - 6 % Five Minutes - 6 %
Five Seconds - 7 % One Minute - 6 % Five Minutes - 6 %
Five Seconds - 7 % One Minute - 6 % Five Minutes - 6 %
CPU Utilization :