D-Link DGS-1100-06/ME - Ipv6 Neighbor Discovery Commands; Create Ipv6 Neighbor_Cache Ipif

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
201
31
IPV6 NEIGHBOR DISCOVERY COMMANDS
The IPv6 Neighbor Discovery commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
create ipv6
neighbor_cache ipif
System <ipv6_addr> <mac_addr>
delete ipv6
neighbor_cache ipif
[system | all] [<ipv6_addr> | static | dynamic | all]
show ipv6
neighbor_cache ipif
[<ipif_name 12> | all] [ipv6address <ipv6_addr> | static | dynamic | all]
config ipv6 nd ns ipif
System retrans_time <integer 1-3600>
show ipv6 nd ipif
System
create ipv6route default
<ipv6addr>
delete ipv6route default
show ipv6route
enable
ipif_ipv6_link_local_auto
System
disable
ipif_ipv6_link_local_auto
System
Each command is listed in detail, as follows:
create ipv6 neighbor_cache ipif
Purpose
Used to add a static neighbor on an IPv6 interface.
Syntax
create ipv6 neighbor_cache ipif System <ipv6_addr>
<mac_addr>
Description
This create ipv6 neighbor_cache ipif command is used to add a
static neighbor on an IPv6 interface.
Parameters
<ipv6_addr> –The IPv6 address of the neighbor.
<mac_addr> –The MAC address of the neighbor.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To create a static neighbor cache entry on the interface System, with an IPv6 address of 3ffc::1 and a MAC address
of 00:01:02:03:04:05: