D-Link DGS-1100-06/ME - Config Router_Ports; Config Igmp Access_Authentication Ports

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
147
ipv4_range <ipaddr> − Specify the IPv4 address to be configured
with the IGMP snooping multicast VLAN group.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure the igmp snooping multicast VLAN:
DGS-1100-06/ME:5#config igmp_snooping multicast_vlan_group default
add ipv4_range 10.90.90.99
Command: config igmp_snooping multicast_vlan_group default add
ipv4_range 10.90.90.99
Success!
DGS-1100-06/ME:5#
config router_ports
Purpose
To configure ports as router ports.
Syntax
config router_ports [vlan_name <string 20> | vlanid <vidlist> |
all] [add | delete] <portlist>
Description
The config router_ports command designates a range of ports as
being connected to multicast-enabled routers. This ensures all
packets with such a router as its destination will reach the multicast-
enabled router − regardless of protocol, etc.
Parameters
vlan_name <string 20> − The name of the VLAN on which the router
port resides. Up to 20 characters can be used.
vlanid <vidlist> − The VLAN id of the VLAN on which the router port
resides.
all − Specifies all ports on the Switch to be configured.
[add | delete] – Specifies whether to add or delete ports defined in
the following parameter <portlist>, to the router port function.
<portlist> − A port or range of ports that will be configured as router
ports.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To delete the static router port:
DGS-1100-06/ME:5#config router_ports vlanid 2 delete 2
Command: config router_ports vlanid 2 delete 2
Success !
DGS-1100-06/ME:5#
config igmp access_authentication ports
Purpose
To configure the IGMP access authentication on the Switch.
Syntax
config igmp access_authentication ports [<portlist> | all] state
[enable | disable]
Description
The config igmp access_authentication ports command