D-Link DGS-1100-06/ME - Show Traffic Control; Config Traffic Trap

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
105
To configure traffic control and enable broadcast storm control system wide:
DGS-1100-06/ME:5#config traffic control all multicast enable unicast disable br
oadcast enable threshold 65
Command: config traffic control all multicast enable unicast disable broadcast
enable threshold 65
Success.
DGS-1100-06/ME:5#
show traffic control
Purpose
To display current traffic control settings.
Syntax
show traffic control {<portlist>}
Description
The show traffic control command displays the current storm traffic
control configuration on the Switch.
Parameters
<portlist> - A port or range of ports whose settings are to be
displayed.
Restrictions
None.
Example usage:
To display traffic control setting:
DGS-1100-06/ME:5# show traffic control
Command: show traffic control
Traffic Storm Control Trap : [None]
Port Thres Broadcast Multicast Unicast Action Count Time
hold Storm Storm Storm down Interval
---- ------- -------------- ------------- ---------- -------- --------- ---------
1 0 Disabled Disabled Disabled Drop 0 0
2 0 Disabled Disabled Disabled Drop 0 0
3 0 Disabled Disabled Disabled Drop 0 0
4 0 Disabled Disabled Disabled Drop 0 0
5 0 Disabled Disabled Disabled Drop 0 0
6 0 Disabled Disabled Disabled Drop 0 0
Total Entries : 6
DGS-1100-06/ME:5#
config traffic trap
Purpose
To configure the traffic control trap on the Switch.
Syntax
config traffic trap [storm_cleared | storm_occured | both | none]